Your privacy is important to us

To ensure that you have the best experience and to help us develop our services we automatically track your session. If you would like to know more about our privacy policy and how we handle your data, click here.

By continuing to browse you are accepting this.

Decline and Leave
Free P+P Bank Holiday

How to make Wedding Card by Ann-marie Vaux



Embossing and die-cutting go together hand in hand, and this shows how fabulous they look together. A truly pretty card that is easy to re-create and very eye-catching.

  • Papercraft
  • < 1 hour
  • Beginner

What You Need

You Will Need:

  • docrafts Xcut Once in a Lifetime Die and Embossing Folder Collection
  • Adhesive Craft Sheets in Holographic
  • 6x6inch white blank card base
  • General white cardstock
  • White satin ribbon bow
  • Crystal embellishments
  • Tape Runner
  • Wet Glue
  • 3D foam
  • Scissors

Instructions:

  1. pot-holder

    Cut a square of white cardstock and emboss using the embossing folder

  2. pot-holder

    Cut out the outside edge of the embossing and then cut out the center of the embossing

  3. pot-holder

    Die cut the adhesive craft sheet using the large square die in the die set

  4. pot-holder

    Then use the Paris in Love die to create the scene in general white cardstock by die-cutting it

  5. pot-holder

    Attach the scene over the top of the holographic adhesive square you have previously die-cut out using the glue of your choice, I used wet glue

  6. pot-holder

    Then attach the holographic scene to the center of the card by peeling the back away from the adhesive sheet

  7. pot-holder

    Add 3D foam to the back of the embossed frame you have previously created

  8. pot-holder

    Attach the frame over the top of the scene that is on the card front already

  9. pot-holder

    Add a bow to the side of the card in the corner

  10. pot-holder

    Finally add a few crystal embellishments to the card on the embossed section