By continuing to browse you are accepting this.
Cut and fold white cardstock to create a 16cm square tent card. Cut a 15cm square from silver cardstock and stick onto the card. Cut a 14.5cm square from navy cardstock and stick onto the card.
Cut a 14cm square from backing paper. Stamp a selection of snowflakes from the Sentiment stamp set onto the square. Sprinkle white embossing powder over the stamped images and shake off the excess. Gently heat the stamped areas with a heat gun until the powder melts and turns glossy. Leave to cool down.
Once cool, lightly spray adhesive onto the square and sprinkle with Frost glitter. Stick the glittery square onto the card.
Cut a 14cm square from white pearl cardstock. Melded dies consist of a decorative element and a demi frame, but can be used individually as well. Using the Melded Elsa and Anna die set, place Elsa and Anna onto the left side of the square and secure with low tack tape. Place the demi frame onto the right side of the square, making sure to line up the die with the decorative element, secure with low tack tape and cut.
Using the Frozen Sentiment stamp set, stamp "Together Forever" with the clear ink pad, sprinkle with silver embossing powder and shake off the excess. Gently heat the sentiment with a heat gun until the powder melts and turns glossy. Leave to cool down.
Cut the Elsa and Anna die again from white pearl cardstock. Trim out the snowflakes and the swirls. Spray with adhesive and glitter with the Frost glitter. Stick the snowflakes directly onto the square with silicone glue.
Using the Frozen Snowflakes, cut one large, two medium and two small from white pearl cardstock. Spray with adhesive and glitter with the Frost glitter.
Pierce three 3mm holes into the square where the two small and one medium snowflakes will sit. Stick the snowflakes over the holes with silicone glue.
Stick the snowflakes and the swirls from step 6 onto the card with silicone glue as shown in the photograph. Leave the square to allow the silicone glue to dry.
Using a 10 string set of Bright Heart Craft Lights, fit a light behind the snowflakes and tape into place if necessary. The wires between the light can be pulled out to make positioning easier. Tape the Battery Pack on the top left corner on the back of the square. Make sure to position the switch so it will be easy to turn off and on.
Using two layers of 4mm foam tape, stick the square onto the card.
Finish with diamanté gems as shown in the photograph.