By continuing to browse you are accepting this.
Trim a card blank to measure 10cm square. Cut some green cardstock a little smaller and mat in the centre. Die cut the word ‘Warm wishes’ from green cardstock, using the lower case script dies. Use the upper case script dies to trim two additional ‘W’s. Snip the curly end from the lower case ‘W’ and glue it into the upper case ‘W’ in a similar position. Trim off the unwanted end above the new curl.
Draw a pencil line onto scrap paper and use as a guide to glue the letters together, using a Sailor 2 In 1 Glue Pen. Stick onto a piece of pink cardstock and use a craft knife to carefully cut away any pink cardstock below the sentiment. Repeat to remove the inside of letter A, and trim any cardstock either side of the word. Repeat this process with ‘Wishes’ and green cardstock, cutting the cardstock above the letters, as well as in the centre of the loops.
Trim a square of white cardstock to fit on top of the green layer with a small border. Snip the green and pink cardstock to fit neatly inside. Fix the sentiment in place with 3D foam squares, and finish with three green stones in the bottom right-hand corner.